inpull

IN-PULL NUT
Available in M6/M8/M10 Bolt Features Easy installation and no special tool required Nut provides a large bearing surface Low profile tag Provides stainless resistance to rust For thin sheet metal from 0.6 to 3.0mm in thickness with PL-6 (from 1.2 to 4.0mm with PL-8, from 1.2 to 7.0mm with PL-10)

Installation Step


Hold tab of IN-PULL NUT asshown above and insert into pre-drilled hole.	Pull tab toward you (Slightly upward). Then bend down the tab.	Position an article to be fastened and fasten it with a bolt.

Size/Material

Material: Stainless Steel AISI 304

Item Number	Bolt Size	Length of Screws	Pre-hole Diameter		Thickness H	Length of Plate L	Length of the Fastener L+L1	Width of Nut B	Width of Tab B1	Breaking Torque N・m(lb・in)	Max Tension Load KN(lb)
Item Number	Bolt Size	Length of Screws	Press	Drill Bit	Thickness H	Length of Plate L	Length of the Fastener L+L1	Width of Nut B	Width of Tab B1	Breaking Torque N・m(lb・in)	Max Tension Load KN(lb)
PL6	M6	H+T+A+α	10.0mm	13/32	3.5mm	15.0mm	28.5mm	9.5mm	14.5mm	10.0 (88.5lb・in)	7.8(1,753lb)
PL8	M8	H+T+A+α	12.5mm	1/2	4.5mm	21.0mm	36.5mm	12.0mm	17.0mm	24.5 (216.8lb・in)	14.7(3,306lb)
PL10	M10	H+T+A+α	15.5mm	1/2	5.0mm	24.0mm	44.3mm	14.3mm	19.6mm	39.2 (346.9lb・in)	19.6(4,405lb)

Warning

Values provided are for reference only.
Carbon steel bolts were utilized in torque testing and repesent maximum values.
Do not exceed these values.
Nut material is AISI 304 Stainless and should not be used in an environment that effects this material.